B&B Electronics ZXT9-IOA-KIT - Manual - Manual (Page 17)

Product Introduction
Manual Documentation Number: ZXTx-IO-x-4113m 11
The following default settings established when the mode is changed:
ZXT24-IO-222R2 ZXT9-IO-222R2
Peer-to-Peer master mode
Radio Network: 0x0c 0x00
Radio ID Number: 0x11 0x11
Radio Output Power: (4) 63mw (4) 1w
Number of Retries: 10 10
AES Security: Disabled Disabled
P2P Address: 1 1
OTA Baud: Fixed* 115200
P2P Polling Rate: 0 sec 0 sec
Peer-to-Peer slave mode
Radio Network: 0x0c 0x00
Radio ID Number: 0x11 0x11
Radio Output Power: (4) 63mw (4) 1w
Number of Retries: 10 10
AES Security: Disabled Disabled
P2P Address: 1 1
OTA Baud: Fixed* 115200
P2P Slave Timeout: 30 sec 30 sec
Modbus mode
Radio Network: 0x0c 0x00
Radio ID Number: 0x11 0x11
Radio Output Power: (4) 63mw (4) 1w
Number of Retries: 10 10
AES Security: Disabled Disabled
Modbus Address: 1 1
OTA Baud: Fixed* 115200
Modbus Slave Timeout: 30 sec 30 sec
* -
“Fixed” for OTA Baud means that this parameter can’t be changed and is equal to 250 Kbps.
Refer to section 6 for parameter descriptions.
2.5.7 Power & I/O Terminals
Screw terminals are provided for Power & I/O interface connections as shown. Refer to Chapter 4 for wiring information.
2.5.8 USB Port
The USB port is used to configure the I/O module and for firmware updates. The I/O module must be connected and powered for the
Zlinx Manager Software to detect the IO module. Refer to section 4 for software installation and section 5 for programming the unit.