B&B Electronics ZXT9-IOA-KIT - Manual - Manual (Page 38)

Configuration & Operation
32 Manual Documentation Number: ZXTx-IO-x-4113m
Fig 6-2 I/O Configuration Tab
6.1.1.1 Transmit Power
In the Transmit Power drop down list, select your desired output power in mW. The conversion between dBm and mW is
shown in Appendix H . Increasing the power will increase maximum range and electrical power consumption. Setting this value
too high may violate regulatory transmission limits for your region and could cause harmful interference to other devices. As a
responsible user, make sure the transmitted power is within allowed limits for your region.
Xtreme Module Power Selections Factory Default
ZXT24-IO-222R2 10mW, 16mW, 25mW, 40mW, 63mW 63mW
ZXT9-IO-222R2 1mW, 10mW, 100mW, 500mW,
1000mW
1000mW
Fig 6-3 Transmit Power Ranges
6.1.1.2 Channel Number
Set the Channel Number field to match the channel used by the device with which it will communicate.
a. If that device is another Zlinx Xtreme I/O Module, set the Channel Numbers the same when configuring each of them.
b. If the device is a Modbus radio modem, the modem must be configured by using Zlinx Radio Modem Configuration
Manager to match the Xtreme Module ’s Channel Number.