Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 71)

10. 4 x 5 Distributor Platform (Optional)
PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 71
Assemble Decking and “W” Corner Post
1. Align A6 and A8 on platform decking weldment with A6 and A8 on the external platform supports.
2. Install platform decking weldment to the platform support channels using twenty four (24)
1/2" x 1" bolt and nuts. (See Figure 10H.)
3. Attach the flange of the toe board short side to the bottom of the 18" decking using two (2)
1/2" x 1" bolt and nuts. Then attach 18" decking to the external platform support using one
1/2" x 1" bolt and nut.
(See Figure 10J on Page 72.)
4. Align flange of end toe board along the bottom of decking. Connect end toe board to decking using
1/2" x 1" bolts and nuts. (See Figure 10I on Page 72.)
5. Install the corner “W” post at the same time as the toe board filler plate. Attach toe board filler plate
to the decking toe boards located across from the entrance. Attach the flat end first using two (2)
5/16" x 3/4" flange bolts and nuts. Then line up the holes of the toe board filler plate with the decking
toe board, while also aligning the holes of the “W” post on the corner. Fasten all three (3) together
with four (4) 5/16" x 3/4" flange bolts and nuts.
(See Figure 10K on Page 73.)
Figure 10H