Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 27)

6. Tie Angles, Ladder Brackets and Safety Cages
PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 27
Ladder Support Brackets
1. Attach ladder support brackets to tie angle using 3/8" x 1" hex bolts (S-7469). Use the holes shown
in Figures 6L-6P on Pages 27-29 for each size elevator.
2. Mount the upper right and upper left hand ladder support brackets to the top tie angle with 3/8" bolts.
3. Mount the lower right hand and lower left hand ladder support brackets to the bottom tie angle with
3/8" bolts.
4. Secure the flanges of the ladder brackets together with 3/8" x 1" hex bolts.
NOTE: You will only use one set of ladder brackets, either the up-leg set or the down-leg set.
Figure 6L Ladder Support Bracket Parts