Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 59)

8. 16"-24" Head Platform Assembly
PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 59
2. Trim two (2) large and two (2) small rails by 15" each so that the remaining length of each rail, both
small and large, is 21". (See Figure 8S.)
a. Install these rails across the Deck A, Deck C, Deck E side of the platform and the opposite side
as shown.
b. Insert one small rail inside of one large rail and telescope the joined rails from the “W” corner post
to the platform post as shown in Figure 8R on Page 58 .
c. Attach to “W” posts (corner posts) and platform posts using nuts (S-3611) and bolts (S-6066).
d. Torque to standard specifications.
Figure 8S 21" Telescoping Handrail
3. Trim two (2) large and two (2) small rails by 4" each so remaining length of each rail, both small and
large, is 32". (See Figure 8T.)
a. Install these rails across the up-leg and down-leg sides of the platform as shown.
b. Insert one small rail inside of one large rail telescope the joined rails from the “W” corner posts
to platform posts as shown in Figure 8R on Page 58 .
c. Attach to “W” posts (corner posts) and platform posts using nuts (S-3611) and bolts (S-6066).
d. Torque to standard specifications.
Figure 8T 32" Telescoping Handrail