Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 58)

8. 16"-24" Head Platform Assembly
58 PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series
Install Intermediate Handrails
IMPORTANT: Trim each rail as listed. Do NOT attempt to make entire adjustment by trimming only one
rail. Each rail must be trimmed and installed as stated for proper fit.
IMPORTANT: For safety purposes, make sure head of bolt is to the inside of platform with nuts on outside
at all connections.
1. Identify and separate the large and small intermediate handrails.
NOTE: The small intermediate handrail (LDR-4088) fits inside of the large intermediate handrail.
It is critical that large and small rails be properly identified in advance. Rails are cut to size and
cutting the wrong rail or to the wrong length will prevent proper installation.
(See Figure 8R.)
Figure 8R Intermediate Handrails