Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 50)

8. 16"-24" Head Platform Assembly
50 PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series
Install Deck C to Main Support Channels
1. Using 3/8" x 1" carriage bolts (S-3585) and 3/8" flange nuts (S-10028), connect Deck C to main
support channel. IMPORTANT: Connect every hole. (See Figure 8F.)
2. Install decking support (HP1624DS) to up-leg end of Deck A as shown. Using five (5) 3/8" x 1" bolts
(S-7105) and 3/8" nuts (S-10028).
3. Install the hatch deck support bar (HP1624HDSX) to Deck C. This piece installs on the underside of
Deck C and extends the width of the deck from edge to edge.
a. Using 3/8" flange nuts (S-10028) and 3/8" x 3/4" flange bolts (S-7105), connect the hatch deck
support bar to the kick plate attached to Deck C and to the hole labeled A2 on decking nearest the
side toe board and lower head. Torque to standard specifications.
(See Figure 8G.)
Figure 8F 16" Deck C to Support Channels
Figure 8G Deck C HP Deck Support as Viewed from Underneath.