Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 46)

8. 16"-24" Head Platform Assembly
46 PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series
Install Deck A and Toe Board
1. Orient the lip of the side toe board (HP1624STBX) out/away from the lower head and slide into place
on non-drive side. Toe board hole A1 should be at the discharge end and A3 is at the up leg end.
2. Locate pre-assembled Deck A, which consists of the hatch opening and connecting flanges.
3. Using a punch as needed for alignment, connect Deck A to the side toe board with 3/8" flange nuts
(S-10028) and 3/8" x 3/4" flange bolts (S-7105). Torque to standard specifications. (See Figure 8B.)
a. Deck hole A1 to toe board hole A1.
b. Deck hole A2 to toe board hole A2.
c. Deck hole A3 to toe board hole A3.
NOTE: Due to snug fit, slide side toe board in place before securing Deck A or any subsequent decking.
Figure 8B Deck A Toe Board Channel Location