Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 19)

PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 19
6. Tie Angles, Ladder Brackets and Safety Cages
Chapter 6: Tie Angles, Ladder Brackets and Safety Cages
Attach Tie Angle to Boot Trunking
1. On the NON-LADDER SIDE, attach tie angle to the trunking using 1/2" x 1" bolts. (See Figure 6A
and Figure 6B.)
a. For 16" Boot Tie Angle: With lip of tie angle up and outward, align tie angle so that it extends
beyond the trunking at each end. (See Figure 6A.)
Figure 6A 16" Boot Tie Angle
b. For 24" Boot Tie Angle: With lip of tie angle up and outward, align edge of tie angle to edge
of trunking at down-leg end. With this alignment, tie angle will extend slightly beyond the edge of
trunking at the up-leg end, as shown in
Figure 6B .
Figure 6B 24" Boot Tie Angle