Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 21)

6. Tie Angles, Ladder Brackets and Safety Cages
PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 21
c. 24" Down-leg boot bracket: Use 3/8" x 1" hex bolts to attach the ladder support brackets to the
boot tie angle using the holes indicated in Figure 6E . Note the outer bracket will have two (2)
empty holes to the outside of the connection at the tie angle.
Figure 6E 24" Boot Bracket Down-Leg
d. 24" Up-leg boot bracket: Use 3/8" x 1" hex bolts to attach the ladder support brackets to the
boot tie angle using the holes indicated in Figure 6F . Note the outer bracket uses the two (2) outer
most set of holes on the tie angle.
Figure 6F 24" Boot Bracket Up-Leg