Velleman HAM263D User Manual
Page 17
HAM263D
03 (15/11/2013)
VELLEMAN
17
•
This function only works with USER CODE 3. The protection zones that are stored in memory
will be bypassed when arming.
The bypassed zones are not monitored and will not trigger
alarms.
•
Enter USER CODE 3,
,
and
.
•
2-beeps confirm correct code entry and the system arms instantly without exit delay.
e.
Arm the system with manual bypass
•
This function allows the temporary bypassing of protection zones, e.g. faulty zones.
•
USER CODE 1 can only bypass zones in partition 1 while USER CODE 2 can only bypass zones
in partition 2. With USER CODE 3, all zones can be bypassed.
•
Make sure that the alarm system is in disarmed mode and the alarm memory is empty. If the
memory is not empty, clear it first (see below).
•
Enter the appropriate USER CODE,
, the zone numbers that need to be bypassed
and
.
•
2-beeps confirm correct code entry, exit delay starts and EXIT/ARMED LED flashes.
•
5-beeps indicate incorrect code entry. Enter the code again.
•
The LEDs indicating the bypassed zones will flash constantly.
•
System will arm after exit delay expires. The appropriate partition LEDs and the EXIT/ARMED
LED are ON.
•
The manual setting of bypassed zones is lost when the system is disarmed.
f.
Disarm the system
•
Simply enter an appropriate USER CODE and
within the entry delay period.
•
The system disarms instantly.
•
2-beeps confirm correct code entry.
•
5-beeps indicate incorrect code entry. Enter the code again after the beeps.
g.
Clear the alarm memory
Before the system can be re-armed in a normal way, the alarm memory must be cleared.
•
Enter an appropriate USER CODE,
,
and
.
•
All zone LEDs will turn off.
•
The system is in disarmed mode and can be re-armed at any time.
h.
Panic button function
At anytime, pressing and holding down any TWO buttons on the keypad simultaneously for more
than three seconds will trigger an alarm. This 24 hour emergency alarm is a software alarm which
is indicated as zone 8. It can not be changed.
i.
Check faulty zone(s)
•
Make sure the system or partition is in disarmed condition.
•
Enter the appropriate USER CODE,
,
and
.
•
The LEDs of the faulty zone(s) will light up.
•
Each display period is 30 seconds. At the end of the period, a beep is generated. If any button is
pressed within 5 seconds after that beep, a new period of 30 seconds begins. The display period
may be prolonged as many times as necessary.
•
The system resumes to normal operation 5 seconds after the beep if no button press is detected.
•
The system does not allow to arm during faulty zone checking and the keypad is temporarily
disabled.
j.
Dynamic battery test
•
The system automatically tests the backup battery once every 24 hours.
•
To initiate a dynamic battery test, disarm the alarm system.
•
Enter USER CODE,
,
and
. The battery LED will flash.
•
Manually initiated testing does not affect the periodic battery test.
•
The test takes 5 seconds to 2 minutes depending on the condition of the battery.
•
Manually battery test is usually required after installation of a new back-up battery.
k.
Dynamic output relay test