Spicer Tandem Drive Axle Dual Range & Double Planetary 34,000-45,000 lbs - Manual (Page 41)

(with carrier removed from axle housing)
NOTE: The following instructions pertain to installation of power divider
on differential carrier with carrier removed from axle housing.
NOTE: Before installing power divider, install related parts as follows:
Install Power Divider on Differential Carrier
1. Output Shaft Side Gear Bearing
Cup.
If removed, press bearing cup
in carrier. Use a press and appro-
priate sleeve or use a brass drift
and a mallet. Tap bearing cup into
its' bore making certain cup is
evenly and firmly seated.
NOTE:
Late Model Axles may
be equipped with a spring and
thrust button mounted between
the input shaft and output shaft
(see page 74).
4.
Apply silicone gasket com-
pound on carrier mating surface
(see illustration).
2. Output Shaft.
Lubricate "O"
rings, then install output shaft
assembly in carrier.
5. Install Power Divider.
Attach
chain hoist to input yoke and
install power divider assembly.
During installation, rotate input
shaft to engage input shaft splines
with inter-axle differential. After
installation, again rotate input
shaft. Output shaft should turn
when input shaft is rotated if
assembly is correct.
NOTE:
Lifting mechanism may
create nicks and burrs on input
yoke. Remove if present.
3. Inter-axle Differential.
Install
differential assembly on output
shaft side gear (with nuts facing
away from output shaft side gear).
6.
If removed, install dowel pins
in carrier. Install power divider
cover cap screws and lock-
washers. (On pump models only,
place socket-head cap screw at
location shown on drawing. Torque
cap screws to 110-125 ft-lbs.
(149-170 Nm).
7. Adjust Input Shaft End Play.
Adjust end play with the power
divider assembled to the differen-
tial carrier. (See page 42.)
41