Power divider overhaul, Disassemble power divider cover (cont'd) – Spicer Tandem Drive Axle Dual Range & Double Planetary 34,000-45,000 lbs User Manual

Page 36

Power Divider Overhaul

Disassemble Power Divider Cover (Cont'd)

Step

(cont'd).

To remove the "larger-diameter"
sliding clutch,

first remove the

lockout (see Shift System Section).

Then remove the sliding clutch

and shift fork (with the two parts

engaged). Grasp the assembly

by hand and maneuver the

assembly past restrictions in

the power divider cover.

To remove the "smaller-diameter"
sliding clutch,

(used on earlier

model axles), the clutch can be

disengaged and removed without

removal of the lockout and shift

fork.

9. Axles with Lube Pump:

With

drive gear locknut previously

removed (step 2) and working

through power divider cover input

shaft bore, gently pry oil pump

drive gear from its shaft. See

steps 10 thru 12 for pump

disassembly.

Remove oil seal from input

bearing cover. Remove bearing

cup from cover.

Remove input shaft bearing

cone. Temporarily place lockout

sliding clutch over rear of input

shaft, teeth toward bearing cone.

Place shaft in press and remove

bearing cone.

10.

Remove oil pump cover cap

screws and lockwashers. Remove

pump cover and "O" ring.

11. *NOTE:

When used, remove

woodruff key from gear shaft,

Remove pump gears from power

divider cover.

12.

Unscrew and remove

magnetic screen from power

divider cover.