Spicer Thick Flange Design Carriers User Manual
Spicer, Drive axles
Spicer
®
Drive Axles
P/N: SHAIS143B
Installation Instruction and Torque Requirements
For Axle Housing Hardware Kit – Thick Flange Design Carriers
Shown below are the torque and installation information for the axle housing hardware parts included in this kit. These
parts and procedures are specific to the models listed below. The capscrews are designed for use on carriers designed
with
“Thick Mounting Flange”.
AXLE HOUSING HARDWARE KIT - USE WITH THICK FLANGE CARRIERS ONLY.
Dana Models: 23105, 26105, 30105S/D
Installation Instructions:
1. Block vehicle tires and disconnect driveline
2. Drain lube and remove axle shafts
3. Remove old carrier fasteners and carrier assembly.
4. Before installing the carrier assembly or new fastener hardware, the axle housing should be visually inspected for
cracks, nicks or burrs on all machined surfaces. Clean the threaded boltholes in the axle housing, removing any paint,
old sealant or oil from the housing and carrier mounting surfaces.
5. Apply a bead of approved RTV sealant (supplied in service kit) to the housing surface. It is important to apply the
sealant around (make a loop) all of the threaded boltholes. Reinstall the carrier assembly.
6. Install new fasteners supplied in kit.
7. Torque the capscrew or nut to the correct specification listed in the chart below.
The “Thick Flange” 23105 Carriers Require
New Longer Style Capscrews at the 12:00 &
6:00 o’clock Positions.
Axle Models
Part-No.
Description
Grade
Thread
Size
Length
lbs-ft
N.m
130218
Carrier to Housing Capscrew (long)
8
.625 - 11
3.25"
160-176
217-239
130184
Carrier to Housing Capscrew (Short)
8
.625 - 11
2.25"
160-176
217-239
Torque Specification Chart - (Carrier - to - Housing Fasteners - Thick Flange)
23105S/D/A
26105S/D/A
30105S/D/A