Spicer Carrier-To-Housing Joint Leak User Manual
Spicer, Carrier-to-housing joint leak repair instructions, Drive axles

Spicer
®
Drive Axles
P/N: SHAIS135
Carrier-To-Housing Joint Leak Repair Instructions
Subject:
This document will explain the recommended repair procedure for a leaking carrier-to-housing joint. This
procedure must be used with original Dana Carrier Installation Kit (P/N 511897) specific contents of this kit are listed
below. Refer to Dana Information Bulletin ABIB-0203 for the proper diagnoses and recommended repair procedure.
Affected Models: D & R 404 Family of Tandem Drive Axles
It is important that you observe all of the normal safety procedures, including wearing proper protection
for every step in this procedure.
Axle Housing Hardware Kit P/N: 511600
Carrier Installation Adapter Kit P/N: 511897 (no longer available thru Dana)
Contents:
1- Forward Carrier Adapter Plate - P/N 130840
1- Rear-Rear Carrier Adapter Plate - P/N 130841
4- Guide Pins - P/N 130843
4- Rear-Rear Adapter Plate Capscrew - P/N 130842
1- Instruction Sheet - P/N SHAIS135B
Required Tool List:
Clean Oil Pan
½” Impact Gun
Wire Wheel or Abrasive Pad
14 mm 12 pt. Impact Socket
Transmission Jack
21 mm Impact Socket
Large screwdriver / Pry-Bar
24 mm Impact Socket
Jack Stands
9/16” Combination Wrench
Hammer / Mallet
24 mm Snap-On Adapter P/N SRDH30-2CL
Installation:
1. Block vehicle tires.
2. Disconnect driveline.
3. Drain axle lube into a
clean pan. Lube will be reused at the end of this procedure.
4. Remove axle shaft nuts, washers and shaft.
5. Remove all but one carrier fastener. The remaining capscrew will hold the carrier in place until the transmission jack
and adapter plate are moved in place and secured