Ohaus DEFENDER 7000 BENCH SCALES Manual en - Manual (Page 51)

7000 Series Indicators EN-49
0.012
kg
ENTER APW
0
Pcs
0.000 KG
*
0
0.000
kg
ENTER APW
*
0
1.476
kg
REMOVE 20 OR
COUNt
Pcs
CLEAR APW?
*
0
0.000
kg
PLACE 10 OR
*
0
0.000
kg
PLACE TOTAL
*
0
1.476
kg
REMOVE 10 OR
123
Pcs
1.476 KG
123
Pcs
1.476 KG
1.200
kg
PLACE 10 OR
To define the APW using parts, place the specified quantity of parts on the scale and
press the FUNCTION button.
To define the APW using a numeric value, enter the value using the keypad, then
press the FUNCTION button.
Positive Counting
After defining the APW, place the items to be counted on the scale and read the value on the display.
The number of pieces appears on the top line and the actual weight appears on the bottom line.
Defining the Average Piece Weight for Negative Counting
Define average piece weight (APW) by removing a specified quantity from a full container on the scale.
When Mode is released, CLEAR APW? is displayed.
Press No to use the stored APW or press the Yes button to define a new APW.
When establishing a new APW, the display alternates between PLACE 10 OR and ENTER APW.
To enable negative counting, press and hold the +/– button until the display shows PLACE TOTAL.
To establish the APW, place the entire quantity of parts on the scale and press FUNCTION.
Then remove the specified quantity of parts from the scale and
press FUNCTION.
NOTE: To change the specified number of pieces, press No repeatedly. The display will step through
the alternative sample sizes: PLACE 5, PLACE 10, PLACE 20, PLACE 50 and PLACE 100.
NOTE: At this stage, it is still possible to define the APW by entering the value using the keypad and
pressing the FUNCTION button.
NOTE: The Total PCS will be cleared when the APW is re-established.
Negative Counting
After defining the APW, read the value on the display. The number of pieces appears on the top line
and the actual weight appears on the bottom line.