Ohaus DEFENDER 7000 BENCH SCALES Manual en - Manual (Page 44)

EN-42 7000 Series Indicators
M-B-B
OUtPUt
CONTACT
B-B-M
CONtAC
SIMULTANEOUS
OUtPUt
STABLE
ON
StAbLE
OFF
I-O
END I-O
mMENU
MENU LOCK
L.mMENU
RESET
YES
rESEt
NO
L.mMENU
LOCK CAL
ON
L.CAL
OFF
L.mMENU
LOCK SETUP
ON
L.SEtUP
OFF
Contact
Set the timing of the relay contacts.
SIMULTANEOUS = the relays open or close at the same time.
B-B-M
= the relay opens before the next relay closes (break-before-make).
M-B-B = the relay closes before the next relay opens (make-before-break).
NOTE: Break-before-make has a 100 ms delay. Make-before-break has a 100 ms over-lap.
Stable
Set the stability condition for the relay to change state.
OFF = relay changes are immediate.
ON = relay changes are delayed until the reading becomes stable.
3.11.5 End I-O
Advance to the next menu or return to the top of the current menu.
3.12 Menu Lock Menu
Use this menu to prevent unauthorized changes to menu settings. When the security switch is
set to ON, the locked menus can be viewed but not changed.
3.12.1 Reset
Reset the Menu Lock menu to the factory defaults. Factory default settings are shown in bold.
NO = not reset
YES = reset
NOTE: Settings for Legal for Trade controlled menu items are not reset.
3.12.2 Lock Calibration
Set the status.
OFF = the Calibration menu is not locked.
ON = the Calibration menu is locked.
3.12.3 Lock Setup
Set the status.
OFF = the Setup menu is not locked.
ON = the Setup menu is locked.