Ohaus DEFENDER 7000 BENCH SCALES Manual en - Manual (Page 42)

EN-40 7000 Series Indicators
99
COmM 2
ADDRESS
01
AddrES
OFF
COmM 1
ALT COMMAND
ALt.CmM
PRINT
Z
PrINt
A
ALt.CmM
TARE
Z
tArE
A
ALt.CmM
ZERO
Z
ZErO
A
COmM1
END COM1
mMENU
I-O
I-O
RESET
YES
rESEt
NO
3.10.6 Address
Set the communication address (COM2 menu only).
OFF = no address
01 to 99 = address 01 to 99
NOTE: The Address menu item is only displayed in the COM2 menu if the optional RS485/RS422
PC Board is installed.
3.10.7 Alternate Command Sub-menu
Enter this sub-menu to set a different command character for the P (Print), T (Tare) or Z (Zero)
commands.
NOTE: The selected character can only be used for one command.
Alternate Print Command
Set the alternate command character for Print.
Settings of A to Z are available. The default setting is P.
Alternate Tare Command
Set the alternate command character for Tare.
Settings of A to Z are available. The default setting is T.
Alternate Zero Command
Set the alternate command character for Zero.
Settings of A to Z are available. The default setting is Z.
3.10.8 End COM1, End COM2
Advance to the next menu or return to the top of the current menu.
3.11 I-O Menu
Enter this menu to set the optional input and output device parameters.
3.11.1 Reset
Reset the I-O menu to the factory defaults.
NO = not reset
YES = reset