Ohaus DEFENDER 7000 BENCH SCALES Manual en - Manual (Page 49)

7000 Series Indicators EN-47
-Off-
*
0.002
kg
*
NET
0.000
kg
*
NET
-1.000
kg
PT
*
NET
0.000
kg
*
1.000
kg
*
0
0.000
kg
*
1.000
kg
*
0
0.000
kg
*
0
0.000
lb
*
0
0.000
kg
05:20 P
4. OPERATION
4.1 Turning Indicator On/Off
To turn the indicator on, press ON/ZERO Off. The indicator performs a display test followed by a
series of informational displays, and then enters the last active mode.
To turn the indicator off, press and hold ON/ZERO Off until -OFF- appears.
If powered by AC mains, the indicator enters standby and displays the clock.
If powered by batteries, the indicator turns off completely.
4.2 Zero Operation
Press ON/ZERO Off to zero the display.
NOTE: The display must be stable and within the Zero Range.
4.3 Manual Tare
Place the container on the scale and press TARE.
NOTE: The display must be stable.
To clear the tare, remove all weight from the scale and press TARE.
4.4 Preset Tare
Enter the preset tare value using the numeric keypad, then press TARE. The display will show the PT
symbol and the tare value as a negative number.
To clear the preset tare, remove all weight from the scale and press TARE.
NOTE: The preset tare value may also be entered or cleared using the xT command. (See Section 5.1.)
4.5 Auto Tare
When Auto Tare is set ON in the Setup menu, the initial item placed on the scale is automatically
tared.
The tare value is automatically cleared when the weight on the scale is fully removed.
4.6 Changing Units of Measure
Press and hold Units until the desired unit of measure is displayed, then release the button.
NOTE: Only units of measure enabled in the Unit menu will be displayed. (See Section 3.7.)