American Magnetics 05100PS-430-601 Integrated Power Supply System - Manual (Page 34)

16 Rev. 5
Installation
Power Requirements
a. Connect the protective diode between the output terminals of the
power supply: anode to the negative (–) terminal and the cathode to
the positive (+) terminal.
b. Connect the positive (+) output terminal (1) of the power supply to
the Model 601 Energy Absorber positive (+) terminal (2).
c. Connect the negative (−) terminal (3) of the Model 601 Energy
Absorber to the positive (+) magnet current lead (4).
d. Connect the negative (−) magnet current lead (5) to the positive (+)
resistive shunt terminal (6) on the back of the Model 430
Programmer.
e. Connect the negative (−) resistive shunt terminal (7) of the Model
430 Programmer to the negative (–) output terminal of the power
supply (8).
f. Connect two jumpers (17) from terminal block position S- to M- and
from S+ to M+ on the power supply unit.
g. Connect the DB15 analog I/O cable from the PROGRAM OUT
connector (14) on the back of the Model 430 Programmer to the
DB15 ANALOG I/O connector (9) on the rear of the power supply
unit.
h. Install an instrumentation cable between the magnet support
stand top plate connector (10) and one of the MAGNET STATION
connectors (16) on the rear of the Model 430 Programmer.
i. Optional: Install an instrumentation cable between one of the LHe
LEVEL / TEMP connectors (15) on the rear of the Model 430
Programmer and the Model 13x Liquid Helium Level Instrument
and/or temperature instrument (11). Refer to section A.2 on page
150.
j. Optional: Install an instrumentation cable between the QUENCH
I/O connector (13) on the rear of the Model 430 Programmer and
Aux connector J2 (12) on the rear panel of the Model 13x Liquid
Helium Level Instrument. Refer to section A.5.2 on page 154.
k. Connect Model 601 power adapter (17) and device line cords, and
plug them into appropriate power receptacles.
l. Remote communications via Ethernet and/or RS-232 can be
accomplished by connecting suitable cabling to the Model 430
Programmer rear panel ETHERNET and/or RS-232 connectors.