American Magnetics 05100PS-430-601 Integrated Power Supply System - Manual (Page 122)

104 Rev. 5
Remote Interface Reference
SCPI Status System
messages in the output buffers will clear the appropriate “Message Available”
bit. The bit definitions for the Status Byte register are defined in Table 4-1.
Bit 2 of the Status Byte register, indicating a quench condition, remains set
until the quench condition is cleared via the front panel or by remote
command. Bits 3 and 4 remain set until all data has been read from the
respective output buffer.
The Status Byte condition register is cleared when:
• A
*CLS
command is executed.
• The Standard Event register is read (only bit 5 of the Status Byte
register is cleared).
• The indicated condition no longer exists.
The Status Byte enable register is cleared when:
• The
*SRE 0
command is executed.
• The power is turned off and then back on, and the Model 430
Programmer was configured for
*PSC 1
(power-on status clear).
The enable register setting is persistent if the Model 430
Programmer is configured for
*PSC 0
(no status clear on power-
on).
Table 4-1. Bit Definitions for the Status Byte Register
Bit Number
Decimal
Value Definition
0 Not Used 1 Always “0”.
1 Not Used 2 Always “0”.
2 Quench Condition 4 The Model 430 has detected a
quench.
3 Serial Message
Available
8 The serial output buffer contains
unread data.
4 Not Used 16 Always “0”.
5 Standard Event 32 One or more enabled bits are set in
the Standard Event register.
6 Status Byte
Summary
64 One or more enabled bits are set in
the Status Byte register.
7 Not Used 128 Always “0”.