American Magnetics 4Q05100PS Four-Quadrant Power Supply - Manual

Rev. 3, February 2004
EXCELLENCE IN MAGNETICS AND CRYOGENICS
American Magnetics, Inc.
P.O. Box 2509, 112 Flint Road, Oak Ridge, TN 37831-2509
Phone: (865) 482-1056 Fax: (865) 482-5472
Internet: http://www.americanmagnetics.com
E-Mail: [email protected]
AMI
AMI MODEL 4Q05100PS
4-QUADRANT POWER SUPPLY
INSTALLATION, OPERATION, AND
MAINTENANCE INSTRUCTIONS
I. INTRODUCTION
The AMI Model 4Q05100PS is designed to provide a compact, 4-quadrant capability for
AMI power supply systems. The Model 4Q05100PS is designed to operate with the AMI
Model 420 Power Supply Programmer.
II. SPECIFICATIONS
________________________________________________________________________________
AC Input Voltage: . . . . . . . . . . . . . . . 100-120 VAC or 200-240 VAC ±10%
1
AC Input Frequency: . . . . . . . . . . . . . 47 to 63 Hz
DC Output Current/Compliance: . . . See Graph 1
Power-Absorbing Mode
2
Rating: . . . . See Graph 2
Output Overvoltage Protection: . . . . ±6 VDC (nominal)
Ambient Temperature Rating . . . . . . 0 to 40°C
352*5$0 ,1 Control Signal:
. . . . . . −
10 to +10 VDC
3
Output Voltage Noise: . . . . . . . . . . . . 0.6 mV RMS into 20 MHz BW (typical)
10 mV p-p into 20 MHz BW (typical)
75 mV p-p into 20 MHz BW (maximum)
Torque Limit on Current Terminals: 50 in-lbs.
________________________________________________________________________________
1
Input voltage range is selectable via an internal switch.
2
The supply is in absorbing mode when the polarity of the output voltage is opposite the
polarity of the current flow.
3 Gain of 0.5 is applied to the voltage output of the unit.