A.13.2 communication via ethernet, Appendix – American Magnetics 05100PS-430-601 Integrated Power Supply System User Manual
Page 196
178
Rev. 5
Appendix
Remote Computer Communication (Ethernet)
8.
Type *IDN? to test
the connection. The
Model 430
Programmer should
respond with
“AMERICAN
MAGNETICS, INC.,
MODEL 430,X.X”
where X.X is the
firmware version.
9.
Issue commands as
A.13.2
Communication via Ethernet
1.
Connect the Model 430 Programmer RJ-45 Ethernet port either
directly to a host computer or through a computer network on
which the host computer resides:
a. For a host computer on a network, connect a standard Ethernet cable
between the Model 430 and the network.
b. For a direct hardwired connection between the Model 430 and a host
computer, use a “null-modem” or “crossover” Ethernet cable connected
from the Model 430 directly to the host computer
2.
Turn on the Model 430 and press <ENTER> at the “Turn on power
supply . . .” prompt.
3.
Press MENU to enter the menu system.
4.
Use < >/< > to navigate to the Net Settings submenu and press
<ENTER>.
5.
Use < >/< > as necessary to navigate to Addr Assignment
(Present).