American Magnetics 05100PS-430-601 Integrated Power Supply System - Manual (Page 200)

182 Rev. 5
Appendix
Model 430 Firmware Upgrade via FTP
2. The Model430.exe upgrade file extracted from the zip file
(typically of the same name) provided by AMI.
3. FileZilla
1
or other appropriate FTP Client installed on the PC. For
this procedure an FTP client called FileZilla is used.
A.14.2 Preparation
1. Install FileZilla or another appropriate FTP Client on the PC that
will used for the upgrade.
2. The AMI Model 430 can be upgraded through a file server, or
similar network, or via direct Ethernet connection to the PC:
a. Via Network:
(1.) Make a new “Upgrade” folder located in an appropriate
location on the file server.
(2.) Extract and save the AMI-supplied upgrade-file,
Model430.exe, to the new folder.
(3.) Ensure that the PC is connected to the network.
(4.) Ensure the Model 430 is connected to the network via
standard Ethernet cable.
b. Direct PC-to-Model 430:
(1.) Make a new “Upgrade” folder located in an appropriate
location on the PC.
(2.) Extract and save the AMI-supplied upgrade-file,
Model430.exe, to the new folder.
(3.) Connect the PC to the Model 430 using a “null-modem”
Ethernet cable (also referred to as an Ethernet “cross-
over” cable).
3. Turn on the Model 430 and press <ENTER> at the “Turn on power
supply . . .” prompt.
4. Press MENU to enter the menu system.
5. Use < >/< > to navigate to Net Settings submenu and press
<ENTER>.
6. Use < >/< > as necessary to navigate to Addr Assignment
(Present).
1. Available free at http://filezilla-project.org/