American Magnetics 05100PS-430-601 Integrated Power Supply System - Manual (Page 211)

Rev. 5 193
Appendix
Model 430:Remote Control Application
1. For a host computer on a network, connect a standard Ethernet
cable between the Model 430 and the network.
2. For a direct hardwired connection between the Model 430 and a
host computer, use a “null-modem” or “crossover” Ethernet cable
connected from the Model 430 to the host computer
3. Once connected, plug in and power up the Model 430.
4. Press <ENTER> after responding to the “Turn on power
supply . . .” prompt.
Note
Allow about 90-seconds (from power-up) for the TCP/IP link between the
Model 430 and host computer to be established.
In order to access the Model 430 using this application, either the Model
430 System Name or IP Address must be known. The System Name should
be available from the Model 430 configuration documentation; the IP
Address can be determined after Model 430 power-up. The following
examples illustrate how the System Name or IP Address may be
determined using the Model 430 menu system:
1. IP Address: Menu > Net Settings > IP Address (Present).
2. System Name: Menu > Net Settings > System Name (Present).
Open a web browser on the host computer. In the address field, type
“http://” followed by either the IP Address or System Name, and press
<ENTER>. For example:
Note
If using the System Name, allow about 90-seconds after power-up
before typing the http address into the browser and pressing
+0.00 A — IP Address (Present)
+0.00 Vs
169.254.91.47 (DHCP)
+0.00 A — System Name (Present)
+0.00 Vs
A10123_X-AX
Figure A-8. http:// - IP Address or System Name Entry