American Magnetics 05100PS-430-601 Integrated Power Supply System - Manual (Page 140)

122 Rev. 5
Remote Interface Reference
Ramp Configuration Commands and Queries
•
LOCK:ABsorber?
Returns “0” for Energy Absorber Present picklist value (under the Load
submenu) unlocked, or “1” for locked.
•
CONFigure:LOCK:BRIGHTness {0|1}
Specifies whether the Display Brightness picklist value (under the Misc
submenu) is locked or unlocked. Sending “0” unlocks. A “1” locks. “0” is the
default value.
•
LOCK:BRIGHTness?
Returns “0” for Display Brightness picklist value (under the Misc
submenu) unlocked, or “1” for locked.
•
CONFigure:LOCK:NETsetup {0|1}
Specifies whether the Net Setup submenu is locked or unlocked. Sending
“0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:NETsetup?
Returns “0” for Net Setup submenu unlocked, or “1” for locked.
•
CONFigure:LOCK:CURRent:RATING {0|1}
Specifies whether the Magnet Current Rating picklist value (under the
LOAD submenu) is locked or unlocked. Sending “0” unlocks. A “1” locks.
“0” is the default value.
•
LOCK:CURRent:RATING?
Returns “0” for Magnet Current Rating picklist value (under the LOAD
submenu) unlocked, or “1” for locked.
•
CONFigure:LOCK:RAMPDown {0|1}
Specifies whether the External Rampdown Enabled picklist value (under
the LOAD submenu) is locked or unlocked. Sending “0” unlocks. A “1”
locks. “0” is the default value.
•
LOCK:RAMPDown?
Returns “0” for External Rampdown Enabled picklist value (under the
LOAD submenu) unlocked, or “1” for locked.
4.5.5 Ramp Configuration Commands and Queries
The ramp configuration commands set the various parameters required for
defining piecewise-linear ramp segments. The external rampdown
function also has the ramp segmenting capability. The function operates in
a manner similar to the normal ramp as described in section 3.7.1 on page
page 35, but parameters can only be edited via the remote interface. See