Actron CP9135 OBD II AutoScanner - Manual (Page 21)

Using the Tool 3-8
Each time you press a key, its name
should appear on the display. For
example, if you press the ▲ /YES
key, the screen will display
“UP / YES.” If key’s name does not
display, then the key is not working. Press the other keys to verify
proper operation.
Check the BACK key last. When
the BACK key is pressed, the
AutoScanner will return to the Tool
Setup/Test menu. If you are not
returned to this menu, then the
BACK key is not working.
3.6.4 Memory Test
If the AutoScanner has trouble performing functions, the Memory
Test should be performed.
From the Tool Setup/Test menu,
select the Memory Test option and
press ENTER to begin.
As the memory is tested, its address is displayed on the bottom line.
After the memory test is done, either a “TEST PASS” or “TEST FAIL”
message is displayed.
Press any key to return to the Tool Setup/Test menu.
3.6.5 Software Identification (SW ID)
The Software Identification is needed when contacting customer
support. Note this in the manual for reference.
From the Tool Setup/Test menu, select the SW ID option and press
ENTER. Note this in the manual for reference.
Press any key to return to the Tool Setup/Test menu.
UP / YES
Press Any Key
BACK
Leaving Keypad Test
Tool Setup
4)Memory Test ]
ROM Test
Testing Addr a500
TEST PASS
Press Any Key
Tool Setup
5)SW ID ]
SW ID: 47H5
Press Any Key