ZyXEL Communications P-2802H(W)(L)-I Series - Manual (Page 87)

Chapter 6 WAN Setup
P-2802H(W)(L)-I Series User’s Guide
87
6.3 WAN Interface Setup
Use this screen to configure your ZyXEL Device’s WAN interface setting. Click Network >
WAN > WAN Interface Setup. If you prefer not to use a VDSL line and you have another
broadband modem or router (such as ADSL) available, you can set the first Ethernet port as
the WAN port and connect that to the broadband modem or router. This way, you can access
the Internet via an Ethernet connection and still use the QoS, Firewall and VoIP functions on
the ZyXEL Device.
Figure 39 WAN Interface Setup
The following table describes the labels in this screen.
Back Click Back to return to the previous screen.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
Table 21 Advanced Internet Access Setup (continued)
LABEL DESCRIPTION
Table 22 WAN Interface Setup
LABEL DESCRIPTION
Active Ethernet
WAN
Select the check box to set the first Ethernet port as a WAN port. The VDSL port
will then be disabled automatically.
This allows the ZyXEL Device to work as an Ethernet gateway, instead of a VDSL
router. To access the Internet, connect the first Ethernet port to a broadband
modem or router.
The ZyXEL Device restarts after you select or clear the check box and click Apply.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.