ZyXEL Communications P-2802H(W)(L)-I Series - Manual (Page 68)

Chapter 4 VoIP Wizard And Example
P-2802H(W)(L)-I Series User’s Guide
68
4 Your ZyXEL Device will attempt to register your SIP account with your VoIP service
provider. When your account is registered your PHONE 1 light will come on and you
are ready to make and receive VoIP phone calls.
Figure 29 SIP Registration Test
5 This screen displays if SIP account registration fails. If your DSL cable was
disconnected, you can try connecting it. Then wait a few seconds and click Register
Again. If your Internet connection was already working, you can click Back and try re-
entering your SIP account settings.
Figure 30 VoIP Wizard Fail
6 This screen displays if your SIP account registration was successful. Click Return to
Wizard Main Page if you want to use another configuration wizard. Click Go to
Advanced Setup page or Finish to close the wizard and go to the main web
configurator screens.
Check here to set up
SIP2 settings.
This screen configures SIP account 1. Select the check box if you have
a second SIP account that you want to use. You will need to configure
the same fields for the second SIP account.
Note: If you configure more than one SIP account, you need
to configure Analog Phone settings to distinguish
between the two accounts when you make and
receive phone calls.
Back Click Back to return to the previous screen.
Apply Click Apply to complete the wizard setup and save your configuration.
Exit Click Exit to close the wizard without saving your settings.
Table 14 VoIP Wizard Configuration
LABEL DESCRIPTION