ZyXEL Communications P-2802H(W)(L)-I Series - Manual (Page 207)

Chapter 14 VPN Screens
P-2802H(W)(L)-I Series User’s Guide
207
14.17 Configuring Global Setting
To change your ZyXEL Device’s global settings, click VPN > VPN Global Setting. The
screen appears as shown.
Figure 115 VPN: Global Setting
The following table describes the fields in this screen.
14.18 Telecommuter VPN/IPSec Examples
The following examples show how multiple telecommuters can make VPN connections to a
single ZyXEL Device at headquarters. The telecommuters use IPSec routers with dynamic
WAN IP addresses. The ZyXEL Device at headquarters has a static public IP address.
14.18.1 Telecommuters Sharing One VPN Rule Example
See the following figure and table for an example configuration that allows multiple
telecommuters (A, B and C in the figure) to use one VPN rule to simultaneously access a
ZyXEL Device at headquarters (HQ in the figure). The telecommuters do not have domain
names mapped to the WAN IP addresses of their IPSec routers. The telecommuters must all
use the same IPSec parameters but the local IP addresses (or ranges of addresses) should not
overlap.
Table 81 VPN: Global Setting
LABEL DESCRIPTION
Windows Networking
(NetBIOS over TCP/IP)
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that
enable a computer to find other computers. It may sometimes be necessary
to allow NetBIOS packets to pass through VPN tunnels in order to allow local
computers to find computers on the remote network and vice versa.
Allow NetBIOS Traffic
Through All IPSec
Tunnels
Select this check box to send NetBIOS packets through the VPN connection.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.