ZyXEL Communications VES-1000 - Manual (Page 61)

VES-1000 Series Ethernet Switch
VLAN Setup 7-1
This chapter shows you how to set up VLAN on the switch using SMT menu 17.
7.1 Introduction
To activate IEEE 802.1Q on the VES-1000 Series switch, you must enable it for the switch in menu 2, the port in
menu 6 port submenu(s) and menu 17 VLAN setup. Menu 17 allows you to enable GVRP on the switch and
configure static VLANs. See elsewhere in this manual for VLAN configuration using menus 2 and 6.
Figure 7-1 Main Setup Menu
7.2 VLAN Setup Configuration
Step 1. Select 802.1Q as the VLAN Type in Menu 2 — Switch Setup.
Step 2. Enter 17 from the main menu to go to Menu 17 — VLAN Setup.
This menu is not available (Menu 17 – VLAN Setup (N/A)) if you have not selected 802.1Q as the
VLAN type in Menu 2 – Switch Setup.
Chapter 7
VLAN Setup
Copyright (c) 1994 - 2001 ZyXEL Communications Corp.
VES-1012 Main Menu ()
Getting Started Advanced Management
1. General Setup
2. Switch Setup 22. SNMP Configuration
3. IP Setup 23. System Password
24. System Maintenance
6. Port Setup
Advanced Applications
12. Static Routing Setup
17. VLAN Setup 99. Exit
Enter Menu Selection Number: