ZyXEL Communications VES-1000 - Manual (Page 112)

VES-1000 Series Ethernet Switch
12-4 VDSL-Related Commands
“downrate” is an integer from 0 to 4 defined in the next table. This command sets the upstream VDSL rate. After
you set the rate, you must use “vdsl reset chan-id” or “vdsl recon chan-id” to make VDSL reconnect.
Table 12-D VDSL Rates
UPRATE/DOWN
RATE
UPSTREAM RATE DOWNSTREAM RATE
10Base-S
0 1.56Mbps 4.17Mbps
1 6.25Mbps 6.25Mbps
2 9.38Mbps 8.33Mbps
3 12.50Mbps 12.50Mbps
4 18.75Mbps 16.67Mbps
ANSI / ETSI Plan 998
0 1.56Mbps 4.17Mbps
1 3.13Mbps 6.25Mbps
2 6.25Mbps 8.33Mbps
3 12.50Mbps
4 16.67Mbps
ETSI Plan 997
0 1.56Mbps 4.17Mbps
1 3.13Mbps 6.25Mbps
2 6.25Mbps 9.38Mbps
3 12.50Mbps
12.2.4 Reset a VDSL Channel
vdsl reset chan-id [lt|nt]
This command issues a software-reset command to the VDSL chip. “lt” is local or the VES-1000 Series switch
VDSL chip; “nt” is the remote VDSL modem chip. The VDSL link first disconnects before the channel resets.
12.2.5 Reconnect a VDSL Channel
vdsl reconnect chan-id
This command forcibly brings up the VDSL channel.
12.2.6 View VDSL Channel Status Command
vdsl status chan-id