ZyXEL Communications VES-1000 - Manual (Page 111)

VES-1000 Series Ethernet Switch
VDSL-Related Commands 12-3
The rest of this chapter shows commonly used VDSL-related CI command examples.
12.2.1 Set VDSL Mode
vdsl mode chan-id (mode)
This command sets the VDSL mode.
After you set the mode is set, you must use “vdsl reset chan-id” or “vdsl recon chan-id” to force
the VDSL channel to reconnect.
The modes are listed here:
Table 12-C Set VDSL Mode by CI Command
MODE NUMBER MODE TYPE
0 10Base-S mode
1 ANSI/ETSI Band Plan 998
2 ETSI Band Plan 997
The band plan is different for each mode even though the speed may be the same.
Please refer to Table 4-C for more information on VDSL mode frequency bands and speeds.
12.2.2 Activate / Deactivate the VDSL Driver
vdsl active chan-id [on|off]
This command actives or deactivates the VDSL driver.
After you set the driver, you must use “vdsl reset chan-id” or “vdsl recon chan-id ” to forcibly bring
up the VDSL channel.
12.2.3 Set Upstream/Downstream VDSL Rates
Upstream
vdsl uprate chan-id [uprate]
“uprate” is an integer from 0 to 4 defined in the next table. This command sets the upstream VDSL rate. After you
set the rate, you must use “vdsl reset chan-id” or “vdsl recon chan-id” to reconnect the VDSL channel.
Downstream
vdsl downrate chan-id [downrate]