ZyXEL Communications VES-1000 - Manual (Page 53)

VES-1000 Series Ethernet Switch
Port Setup 5-3
5.2.2 Ethernet Port Setup
Ethernet port connections can be half duplex or full duplex. The Ethernet port must use the same speed / duplex
mode setting as the peer Ethernet port in order to connect.
Please refer to section 2.4.3 for Ethernet port default settings and section 4.2.3 for information on port trunking.
Select an Ethernet port and then press [ENTER] to go to the Ethernet port setup menu.
Figure 5-3 Menu 6.13 – Ethernet Port Setup
The Menu 6.13 – VDSL Port Setup fields are explained in the next table.
Table 5-B Menu 6.13 – Ethernet Port Setup
FIELD DESCRIPTION EXAMPLE
User Name Choose a descriptive name for identification purposes. This name can be
up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes “-” and underscores "_" are accepted. Uplink1
Active Press [SPACE BAR] to select Yes or No and press [ENTER] to enable or
disable the specified Ethernet port. Yes
Type This read-only (r.o.) field displays the type of port you are currently
configuring. (Ethernet ports 13 & 14 relate to the VES-1012 switch only). Ethernet
Speed Set Ethernet transmission speed (10 or 100 Mbps) in this field. The VES-
1000 Series switch automatically finds the speed of the attached device if
you select Auto; otherwise check the settings of the device attached to this
port and configure the same settings here. Press [SPACE BAR] to select
from Auto, 100M or 10M and then press [ENTER]. Auto
Duplex Set Ethernet duplex mode (full-duplex or half-duplex) in this field. The
VES-1000 Series switch automatically finds the mode of the attached
device if you select Auto; otherwise check the settings of the device
attached to this port and configure the same settings here. Press [SPACE
BAR] to select from Auto, Full or Half and then press [ENTER]. Auto
Flow Control Enable or disable flow control on the Ethernet port in this field. Press
[SPACE BAR] to select either Enable or Disable. Enable
Edit Spanning
Tree Protocol Press [SPACE BAR] once to select Yes and then press [ENTER] to go to
Menu 6.1 - Port Spanning Tree Protocol Setup. You must enable STP No
Menu 6.13 – Ethernet Port Setup
User Name = Uplink1
Active = Yes
Type = ETHERNET (r.o)
Speed = Auto
Duplex = Auto
Flow Control = Yes
Edit Spanning Tree Protocol Setup= No
Edit VLAN Setup= No
Default Port Priority= 0
Press Enter to Confirm or ESC to Cancel: