ZyXEL Communications ZyXEL Dimension ES-2108 - Manual (Page 60)

ES-2108 Series User’s Guide
60 Chapter 5 Initial Setup Example
1 Click Advanced Application and VLAN in the navigation panel and click the Static
VLAN link.
2 In the Static VLAN
screen, select ACTIVE,
enter a descriptive name
in the Name field and
enter 2 in the VLAN
Group ID field for the
VLAN2 network.
Note: The VLAN Group
ID field in this
screen and the VID
field in the IP Setup
screen refer to the
same VLAN ID.
3 Since the VLAN2
network is connected to
port 5 on the switch,
select Fixed to
configure port 5 to be a
permanent member of
the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the switch to remove VLAN tags before
sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the switch’s power is turned off.
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines.