ZyXEL Communications ZyXEL Dimension ES-2108 - Manual (Page 231)

ES-2108 Series User’s Guide
Chapter 33 Interface Commands 231
C
H A P T E R
33
Interface Commands
These are some commonly used configuration commands that belong to the interface
group of commands.
33.1 Overview
The interface commands allow you to configure the switch on a port by port basis.
33.2 Interface Command Examples
This section provides examples of some frequently used interface commands.
33.2.1 interface port-channel
Use this command to enable the specified ports for configuration. Indicate multiple, non-
sequential ports separated by a comma. Use a dash to specify a port range.
Syntax:
interface port-channel
An example is shown next.
• Enter the configuration mode.
• Enable ports 1, 3, 4 and 5 for configuration.
• Begin configuring for those ports.
33.2.2 broadcast/multicast storm control
Syntax:
bmstorm-limit
bmstorm-limit
sysname# config
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)#