2 resetting commands, 3 re-enable commands, 4 other examples of no commands – ZyXEL Communications ZyXEL Dimension ES-2108 User Manual
Page 223
ES-2108 Series User’s Guide
Chapter 32 Configuration Mode Commands
223
32.4.2 Resetting Commands
Use the
no
command to reset switch settings to their default values.
Syntax:
no https timeout
Resets the https session timeout to default.
An example is shown next. The session timeout is reset to 300 seconds.
32.4.3 Re-enable commands
The no command can also be used to re-enable features which have been disabled.
Syntax:
no ip route
where
An example is shown next.
• Enable the IP route with the IP address of 192.168.11.1 and subnet mask of
255.255.255.0. This ip route must have already been created and made inactive prior to
re-enable command being applied.
32.4.4 Other Examples of no Commands
In some cases the
no
command can disable a feature, disable an option of a feature or disable a
feature on a port by port basis.
sysname(config)# no https timeout
Cache timeout 300
=
Re-enables an ip route with the specified IP address and
subnet mask.
sysname(config)# no ip route 192.168.11.1 255.255.255.0 inactive