Yamaha DIGITAL MIXING STUDIO 01X User Manual
Page 93
01X Owner’s Manual
Function Tree/Function List
93
Before Using
Basics Section
Appendix
Getting Started
Reference
DIO (Digital In/Out) [UTILITY] → Channel knob 4
1
D.IN ST-BUS CASCADE (Digital In Stereo Bus Cascade)
b
ON/OFF
Determines whether cascade connection to the stereo bus is enabled or not for
the external device connected to the DIGITAL STEREO IN terminal.
No
!6
y
ATT (Attenuate)
This control is used to attenuate Cascade Input signals.
No
!7
m
SRC (Sampling rate
converter)
Turns the sampling rate converter for DIGITAL STEREO IN on and off.
No
w
2
D.OUT DITHER (Digital Out Dither)
r
/
t
OFF
16bit
20bit
24bit
When digital audio is transferred to lower-resolution systems, truncated bits
may generate undesirable noise. To cancel the audible effect of this noise, a
small complement of noise is intentionally added to the digital outputs. This
process is called “dithering.” On the 01X, you can dither the Digital Stereo
Out. For example, you can apply dithering to the 01X stereo mix data and
record to a 16-bit DAT recorder.
Dithering is effective only when the resolution of the receiving device is lower
than that of the 01X.
The sound quality may be less than optimum if this is not set properly.
No
@6
OSC (Oscillator) [UTILITY] → Channel knob 5
1
OSCILLATOR
b
ON/OFF
The 01X features an Oscillator you can use for sound check and testing pur-
poses. This turns the Oscillator on or off.
• To prevent any sudden tone bursts in your monitors or headphones, set
the LEVEL parameter to minimum (-96dB) before turning on the Oscilla-
tor.
No
!9
y
LEVEL
-96dB – 0dB
Determines the Oscillator output level.
No
@0
u
WAVEFORM
Select the Oscillator waveforms: SINE 100Hz, SINE 1kHz, SINE 10kHz or
WHITE NOISE.
No
!8
2
OSC. ASSIGN (Oscillator Assign)
z
RECBUS
Determines the transmission destination of the Oscillator. The selected bus is
indicated in brackets (for example:
No
@2
c
–
n
AUX1 – 4
No
,
ST-BUS
No
Knob
Function name/
settings
Explanation
Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [
/
]
[PAGE SHIFT] + DISPLAY [
/
]