Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 62)

62
Mixing Tutorial
01X Owner’s Manual
Before Using
Basics Section
Appendix
Getting Started
Reference
Routing audio to the digital stereo output
In the section above you learned how to route digital audio
into the 01X.
In this section, we’ll see how to send it back out again.
One common routing would be to send the entire stereo
mix to the digital output for recording. Another would be
to use the digital output as an aux stereo send for external
effects.
■ Operation
q Connect the digital source to the DIGITAL STEREO
OUT jack on the rear panel.
If you are using the digital output as an aux send, make
sure your external effect processor has an appropriate
digital input. If you are recording the stereo mix, use
the digital input on your recorder (DAT deck, etc.). As
above, the 01X connectors are S/PDIF; make sure the
device you are connecting has the same.
w Call up the Utility mode by pressing the [UTILITY]
button.
e Press knob 2 to call up the Patch parameters.
r Select page 6 with the DISPLAY [ / ] (Up/Down)
buttons.
Page 6 contains Output Patch settings for the DIGITAL
STEREO OUT and STEREO/AUX OUT jacks.
t Use knob 1 to change the assignment to the DIGITAL
STEREO OUT jack.
If you want to use the digital output as an aux send, set
this to “AUX1/2.”
Using the Aux 1/2 sends for external effects lets you
retain the Aux 3/4 sends for the internal effects. You’ll
also need to make other settings, such as routing the
external effect signal back into the 01X (page 88). For
more details on using external effects, see page 60.
If you want to send the stereo mix to the digital output
for recording, set this to “RECBUS.”
Make sure to save your important Patch setups to the
Output Patch Library so that you can call them up in
the future. (See page 91.)
UTILITY OUTPUT PATCH (DIGI. ST/AUX OUT PORT) 6/8
[ST-BUS]≥D.OUT [ST-BUS]≥ST/AUX OUT
Page number (current
page is 6 of 8 total) DIGITAL STEREO
OUT STEREO/AUX
OUT
UTILITY OUTPUT PATCH (DIGI. ST/AUX OUT PORT) 6/8
[AUX1/2]≥D.OUT [ST-BUS]≥ST/AUX OUT
UTILITY OUTPUT PATCH (DIGI. ST/AUX OUT PORT) 6/8
[RECBUS]≥D.OUT [ST-BUS]≥ST/AUX OUT