Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 23)

01X Owner’s Manual
Connections
23
Before Using
Basics Section
Appendix
Getting Started
Reference
Connections
• Before connecting the 01X to other electronic components, turn off the power to all the components.
Before turning the power on or off to all components, set all volume levels to minimum (0). Otherwise,
electrical shock or damage to the components may occur.
The following diagram shows a typical example of connections to the 01X. Connect your microphones, instru-
ments, and external devices as shown in this diagram.
• For information on installing the mLAN driver and connecting the 01X to your computer via mLAN as well as information
on necessary system requirements, refer to the separate Installation Guide.
● Wordclock
Digital audio equipment must be synchronized when digital audio signals are transferred from one device to another. Even
if both devices use identical sampling rates, digital signals may not transfer correctly, or audible noise or unwanted clicks
may occur if the digital audio processing circuits inside each digital audio device are not synchronized with each other.
Wordclocks are signals that enable digital audio processing circuits to synchronize with each other. In a typical digital
audio system, one device operates as the wordclock master, transmitting wordclock signals, and the other devices operate
as wordclock slaves, synchronizing to the wordclock master. If you are digitally connecting the 01X to other equipment, you
must decide which device to use as the wordclock master and which devices to use as slaves, then set up all the devices
accordingly. The 01x can be used as the wordclock master running at either 44.1 kHz, 48kHz, 88.2 kHz (Macintosh only),
or 96 kHz, or slaved to an external wordclock source. When mLAN is used, the 01X’s mLAN Auto Wordclock must be set to
ENABLE (page 92).
DIGITAL
STEREO IN
DIGITAL
STEREO OUT
MONITOR OUT
MIC/LINE INPUT
MIDI IN
MIDI OUT
MIC/LINE INPUT
1
FOOT
SWITCH
1
2
PHONES
2
8 (HI-Z)
3 ~ 8
01X mLAN MUSIC PRODUCTION STUDIO
Copyright(c) Yamaha
IEEE 1394-equipped Computer
Foot Switch FC5 or FC4
Monitor system
Headphones
Electric guitar/Electric bass
Synthesizer/Tone generator
DAT recorder, MD recorder, etc.
Microphone