Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 101)

01X Owner’s Manual
Function Tree/Function List
101
Before Using
Basics Section
Appendix
Getting Started
Reference
b RECALL
For calling up the selected Dynamics effect. The confirmation prompt can be
turned on/off as desired. (See “Recall Confirmation” on page 95.)
Yes 54
n STORE
Dynamics settings are stored to internal memory in the Dynamics Library. Up
to 88 Dynamics settings can be stored. The confirmation prompt can be turned
on/off as desired. (See “Store Confirmation” on page 95.)
• Any and all data in the Store destination will be lost when executing the
Store operation. Make sure to save and archive important data to com-
puter using the Studio Manager program (page 9).
Yes 65
m CLEAR This deletes the selected EQ Library. Yes
GROUP [INTERNAL] → ([SELECTED CHANNEL]) → [GROUP]
FADER GROUP/FD-GRP
q – i
( q )
GRP-A/B/C/D
Input Channel or Output Channel faders (the level controls) can be grouped.
There are four (A through D) Channel fader groups. When channel faders are
grouped, operating one of them enables you to control the level of the other
grouped faders while maintaining the relative level differences.
• If you add one channel from a pair to a group, the pair partner is automat-
ically added to the group.
• You can also select a channel on another Layer by switching Layers.
• You can temporarily disable a Fader group in order to make adjustments to
individual faders by operating the fader while holding down its [SEL] but-
ton.
No
MUTE GROUP/MT-GRP
q – i
( w )
GRP-E/F/G/H
Input Channel or Output Channel [ON] buttons can be grouped. There are
four (E through H) Channel Mute groups. When channel [ON] buttons are
grouped, pressing any one of them turns the [ON] buttons for all the grouped
channels on or off. A mute group can include On channels and Off channels at
the same time, which turn off or on respectively when you press any one of the
grouped [ON] buttons.
• If you add one channel from a pair to a group, the pair partner is automat-
ically added to the group.
• You can also select a channel on another Layer by switching Layers.
• If you wish to turn a subset of the grouped channels on or off, first turn
ENABLE (below) off, or remove the channels you wish to turn on or off
from the group.
No
GROUP ENABLE
q – i ENA/---
This parameter enables (ENA) or disables (---) the Groups. When the group is
set to disable (---), the corresponding group is temporarily cancelled.
No
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]