Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 147)

Before Using
Basics Section
Appendix
Getting Started
Reference
01X Owner’s Manual
147
Troubleshooting
■ The pitch is wrong.
• Is the 01X operating on the same sampling frequency as
the synchronized external device? ...................................................... page 92, “Settings by mLAN Auto Connector” (Installation Guide)
• Is the master device operating in a stable way?
• Is an effect such as HQ.Pitch or Dual Pitch selected?..................................................................................................................... page 102
■ The layer of 17-24 (mLAN9-16) cannot be used.
• When the sampling rate is set to 96kHz/88.2kHz, the layer of 17 – 24 (mLAN) can not be selected.............................................. page 40
■ Cannot edit with Studio Manager.
• Has the STUDIO MANAGER ID been set correctly? ...................................................................................................................... page 94
• Is Port 4 (Studio Manager) selected for Studio Manager data transmission/reception? ............... Studio Manager Owner’s Manual (PDF)
■ The Remote Control or Automation features do not work.
• Is the correct DAW software selected in Remote Select? ................................................................................................................. page 87
• Are the mLAN settings correct?........................................................................................................................................ Installation Guide
• Are settings on the DAW correct? ...................................................................................................................... page 67, Installation Guide
• Is Port 1 selected for mLAN MIDI transmission/reception?.............................................................................. page 67, Installation Guide
■ Cannot change the wordclock.
• Set this with the mLAN Auto Connector when using mLAN........................... “Settings by mLAN Auto Connector” (Installation Guide)
• Is the mLAN Auto Wordclock (AUTO W.CLK) setting appropriate? .............................................................................................. page 92
■ Cannot install the driver.
• Is the mLAN cable properly connected? Check the connection; disconnect the mLAN cable once, then insert it again.
■ The mLAN connection does not work.
• Has the driver been installed?............................................................................................................................................ Installation Guide
• Is the mLAN cable properly connected? Check the connection; disconnect the mLAN cable once, then insert it again.
• (For Windows) Is mLAN set to “ON”? From the taskbar, right click on the mLAN Manager icon. .............................. Installation Guide
• (For Windows) When adding a new IEEE 1394 card, right click on the
mLAN Manager icon in the taskbar and select “ON.”. ..................................................................................................... Installation Guide
• Is the ACTIVE lamp on the rear panel of the 01X lit (in blue)? If it is not lit, check the followings:
• In mLAN Driver Setup (from taskbar, right click on the mLAN Manager icon,
then “Driver Setup”), is the Status indicator blue? If not, restart the 01X and
re-enable connection by using mLAN Auto Connector. ................................................................................................... Installation Guide
• Is mLAN AUTO W.CLK (Auto Wordclock) on the 01X set to “ENABLE”?................................................................................... page 92
• Has connection been enabled with mLAN Auto Connector?
Re-enable connection if necessary..................................................................... “Settings by mLAN Auto Connector” (Installation Guide)
• Have you changed the device? Even if the model is the same,
if the actual device is different, it is necessary to re-enable
connection by using Auto Connector................................................................. “Settings by mLAN Auto Connector” (Installation Guide)
• Is there a loop connection? Check the cabling and make sure none of the devices are connected in a loop.
Computer
Computer
01X
01X
: IEEE 1394-equipped device
Example of loop connection