Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 100)

100
Function Tree/Function List
01X Owner’s Manual
Before Using
Basics Section
Appendix
Getting Started
Reference
SEND [INTERNAL] → ([SELECTED CHANNEL]) → [SEND]
SEND 1 – 4 (AUX Send Level 1 – 4 )
q – i
( w / y )
-
∞
– +6.0
Determines the Aux Send level of the Input Channels. When the channel knob
is pressed, the level is set to nominal (0dB).
• To assign a pair, simultaneously press and hold down the [SEL] button for one
AUX bus and press the [SEL] button of the adjacent AUX (paired numbers
should be odd/even and in order). (See page 102.)
• When using an internal effect via the Aux Send, do NOT turn up the send
level to the corresponding AUX bus for the channel to which the effect
return signal is routed. Doing so will result in loud feedback, and may
damage your equipment. For example, when the 01X is in the default
condition, AUX 3 is routed to the input of internal effect 1, and the L/ R
signals of the ST IN channel 1 are routed to the output. If you turn up the
send level of ST IN channel 1 to AUX 3, a feedback loop is created.
No
!4
AX 1 – 4-PP/AUX 1 – 4PREPOST (AUX1 – 4 PRE/POST)
q – i
( e / u )
PRE/POST
Determines the Aux Sends signal source points. The PRE sends pre-fader sig-
nals, and the POST sends post-fader signals.
No !2
ON/OFF (Selected Channel only)
( q / t ) ON/OFF
Determines whether Aux Send is on or off. The channel is muted with the Off
setting.
No
!3
DYNAMICS [INTERNAL] → ([SELECTED CHANNEL]) → [DYNAMICS]
ON/OFF
q – i
( q )
Determines whether Dynamics is on or off. Parameters depend on the
Dynamics Types selected in the Library as follows. Dynamics is not available
for the ST IN channels.
No
i
Parameters 1 – 6 (Selected Channel only)
( e – i ) For adjusting the Dynamics parameters 1 through 6 individually. No
DYNAMICS LIBRARY (Selected Channel only)
q – r 01 – 128
Determines the Library number. Preset Dynamics numbers are indicated by
asterisks (*) in the display and cannot be changed.
No 118
z – v (Title Edit) Determines the title (name) of the Dynamics Library. No 41
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]
Dynamics
Type Compressor/
Expander
Compander
Gate
Ducking
Knob
Parameter 1 THRESH THRESH THRESH 3
Parameter 2 RATIO RATIO RANGE 4
Parameter 3 ATTACK ATTACK ATTACK 5
Parameter 4 RELEASE RELEASE DECAY 6
Parameter 5 GAIN GAIN HOLD 7
Parameter 6 KNEE WIDTH KEY-IN 8
[PAGE SHIFT] + DISPLAY [ / ]