Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 89)

01X Owner’s Manual
Function Tree/Function List
89
Before Using
Basics Section
Appendix
Getting Started
Reference
3 INPUT PATCH (ST1/2) (Input Channel Stereo 1/2)
q
NONE, AD1/2 – AD7/8,
D.IN/FX1 → STI1
Determines the input signal routing for Stereo Input channels (STI1/2). The
settings “FX1”and “FX2” correspond to the outputs of internal effects. The
settings “AD1/2” – “AD7/8” correspond to MIC/LINE INPUTS 1 – 8, while
“DIN” corresponds to the DIGITAL STEREO IN signals. Turning the knob
immediately changes the routing. To disable input for the desired channel,
select “NONE.”
• The same input signal can be simultaneously routed to several different
input channels.
• The Input Patch settings made here can be stored to the Input Patch
Library (see below).
No
27
61
r
e
NONE, AD1/2 – AD7/8,
D.IN/FX2 → STI2
(44.1kHz/48kHz mode
only)
No
4 INPUT PATCH LIBRARY
q – r
00 – 32
(Library number)
Determines the Library number. Preset Patch numbers are indicated by aster-
isks (*) in the display and cannot be changed. Library number 00 is read-only
and contains the default settings for the Patch. By using Recall (below) to call
up this Patch, you can restore Input Patch settings to their initial default state.
No
z – v (Title Edit) Determines the title (name) of the Patch Library. No
b RECALL
For calling up the selected Patch. The confirmation prompt can be turned on/
off as desired. (See “Recall Confirmation” on page 95.)
Yes 54
n STORE
An Input Patch is stored to internal memory in the Input Patch Library. Up to
32 Input Patch can be stored. The confirmation prompt can be turned on/off as
desired. (See “Store Confirmation” on page 95.)
• Any and all data in the Store destination will be lost when executing the
Store operation. Make sure to save and archive important data to com-
puter using the Studio Manager program (page 9).
Yes 65
m CLEAR This deletes the selected Input Patch. Yes
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram