ZyXEL Communications P-661H Series - Manual (Page 119)

P-661H/HW Series User’s Guide
Chapter 6 Wireless LAN 119
6.4.5 Wireless LAN Advanced Setup
To configure advanced wireless settings, click the Advanced Setup button in the General
screen. The screen appears as shown.
Figure 59 Wireless LAN: Advanced
The following table describes the labels in this screen.
Cancel Click Cancel to reload the previous configuration for this screen.
Advanced Setup Click Advanced Setup to display the Wireless Advanced Setup screen and
edit more details of your WLAN setup.
Table 40 Wireless: WPA/WPA2
LABEL DESCRIPTION
Table 41 Wireless LAN: Advanced
LABEL DESCRIPTION
Wireless Advanced Setup
RTS/CTS
Threshold
Enter a value between 0 and 2432. If you select the Enable 802.11g+ mode
checkbox, this field is grayed out and the ZyXEL Device uses 4096 automatically.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256
and 2432. If you select the Enable 802.11g+ mode checkbox, this field is grayed
out and the ZyXEL Device uses 4096 automatically.
Output Power Set the output power of the ZyXEL Device in this field. This control changes the
strength of the ZyXEL Device's antenna gain or transmission power. Antenna gain is
the increase in coverage. Higher antenna gain improves the range of the signal for
better communications. If there is a high density of APs within an area, decrease the
output power of the ZyXEL Device to reduce interference with other APs.
The options are Maximum, Middle and Minimum.