beautypg.com

1 no security, 2 wep encryption, 1 no security 6.4.2 wep encryption – ZyXEL Communications P-661H Series User Manual

Page 114: Figure 55 wireless: no security, Table 37 wireless: no security

background image

P-661H/HW Series User’s Guide

114

Chapter 6 Wireless LAN

6.4.1 No Security

Select No Security to allow wireless clients to communicate with the access points without
any data encryption.

Note: If you do not enable any wireless security on your ZyXEL Device, your network

is accessible to any wireless networking device that is within range.

Figure 55 Wireless: No Security

The following table describes the labels in this screen.

6.4.2 WEP Encryption

WEP encryption scrambles the data transmitted between the wireless clients and the access
points to keep network communications private. It encrypts unicast and multicast
communications in a network. Both the wireless clients and the access points must use the
same WEP key.

Your ZyXEL Device allows you to configure up to four 64-bit, 128-bit or 256-bit WEP keys
but only one key can be enabled at any one time.

In order to configure and enable WEP encryption; click Network > Wireless LAN to display
the General screen. Select Static WEP from the Security Mode list.

Table 37 Wireless: No Security

LABEL

DESCRIPTION

Security Mode

Choose No Security from the drop-down list box.

Apply

Click Apply to save your changes back to the ZyXEL Device.

Cancel

Click Cancel to reload the previous configuration for this screen.

Advanced

Setup

Click Advanced Setup to display the Wireless Advanced Setup screen and edit

more details of your WLAN setup.

This manual is related to the following products: