ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 219)

Dimension GS-3012F Gigabit Ethernet Switch
IEEE 802.1Q Tagged VLAN Commands 30-3
Syntax:
show garp
This command shows the switch’s GARP timer settings, including the join, leave and leave all timers.
An example is shown next.
Figure 30-3 GARP STATUS Command Example
30.4.2 GARP Timer
Syntax:
garp join leave leaveall
where
join
=
This sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is
between 100 and 32767 milliseconds; the default is 200 milliseconds.
leave
=
This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600 milliseconds.
leaveall
=
This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
This command sets the switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
30.4.3 GVRP Timer
Syntax:
show vlan1q gvrp
GS-3012F (config)# garp join 300 leave 800 leaveall 11000
GS-3012F # show garp
GARP Timer
------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
GS-3012F#