ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 202)

Dimension GS-3012F Gigabit Ethernet Switch
29-4 Command Examples
29.2.6 show mac address-table
Syntax:
show mac address-table |static>
Where
= Specifies the sorting criteria (MAC, VID or port).
This command displays the MAC address(es) stored in the switch. The following example shows a static MAC
address table.
Figure 29-6 show mac address-table Command Example
29.3 ping
Syntax:
ping < [in-band|out-of-band|vlan ] [ size <0-8024> ] [ -
t ]>
where
= The IP address of an Ethernet device.
[in-band|out-of-
band|vlan id> ]
= Specifies the network interface or the VLAN ID to which the Ethernet
device belongs.
out-of-band refers the management port while in-band means the
other ports on the switch.
[ size <0-
8024> ] = Specifies the packet size to send.
[ -t ] = Sends Ping packets to the Ethernet device indefinitely. Click [CTRL]+
C to terminate the Ping process.
This command sends Ping packets to an Ethernet device. The following example sends Ping requests to and
displays the replies from an Ethernet device with an IP address of 192.168.1.100.
Figure 29-7 ping Command Example
29.4 traceroute
GS-3012F# show mac address-table static
Vid Mac Port Status
1 01:a0:c5:aa:aa:aa 1 Permanent
GS-3012F#
GS-3012F# ping 192.168.1.100
sent rcvd rate rtt avg mdev max min reply from
1 1 100 0 0 0 0 0 192.168.1.100
2 2 100 0 0 0 0 0 192.168.1.100
3 3 100 0 0 0 0 0 192.168.1.100
GS-3012F#