ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 203)

Dimension GS-3012F Gigabit Ethernet Switch
Command Examples 29-5
Syntax:
traceroute [in-band|out-of-band|vlan ][ttl <1-255>] [wait
<1-60>] [queries <1-10>]
where
= The IP address of an Ethernet device.
[in-band|out-of-
band|vlan
id> ]
= Specifies the network interface or the VLAN ID to which the Ethernet
device belongs.
[ttl <1-255>] = Specifies the Time To Live (TTL) period.
[wait <1-60>] = Specifies the time period to wait.
[quesries <1-
10>]
= Specifies how many tries the switch performs the traceroute function.
This command displays information about the route to an Ethernet device. The following example displays route
information to an Ethernet device with an IP address of 192.168.1.100.
Figure 29-8 traceroute Command Example
29.5 Enabling RSTP
To enable RSTP on a port. Enter “ spanning-tree ” followed by the port number and press [ENTER]. The
following example enables RSTP on port 10.
Figure 29-9 Enable RSTP Command Example
29.6 Configuration File Maintenance
This section shows you how to backup or restore the configuration file on the switch using TFTP.
29.6.1 Backing up Configuration
Syntax:
copy running-config tftp
where
= The IP address of a TFTP server on which you want to store the backup
configuration file.
GS-3012F> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
GS-3012F (config)# spanning-tree 10
GS-3012F#