ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 194)

Dimension GS-3012F Gigabit Ethernet Switch
28-20 Introduction to CLI
Table 28-4 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
fixed Specifies the port(s) to be a permanent
member of this VLAN group.
forbidden
list>
Specifies the port(s) you want to prohibit
from joining this VLAN group.
untagged
list>
Specifies the port(s) you don’t want to
tag all outgoing frames transmitted with
this VLAN Group ID.
inactive Disables the specified VLAN.
help Displays a list of available VLAN
commands.
no fixed list> Sets fixed port(s) to normal port(s).
forbidden
list>
Sets forbidden port(s) to normal port(s).
untagged
list>
Specifies the port(s) you want to tag all
outgoing frames transmitted with this
VLAN Group ID.
inactive Enables the specified VLAN.
ip address
inband-default
dhcp-bootp
Sets the default in-band interface to use
a static IP address in this VLAN.
The switch will use the default IP
address of 0.0.0.0 if you do not
configure a static IP address.
ip address
default-gateway
Deletes the default gateway from this
VLAN.
ip address
address>
Deletes the IP address and subnet
mask from this VLAN.
exit Leaves config-vlan mode.
ip address inband-default
dhcp-bootp
release
Releases the dynamic in-band IP
address.
inband-default
dhcp-bootp renew Updates the dynamic in-band IP
address.
inband-default
dhcp-bootp
Sets the dynamic in-band IP address.
inband-default Sets a static in-band IP address and
subnet mask.
default-gateway
Sets a default gateway IP address for
this VLAN.